Hoist Fitness CF-3461-3 owner manual Hoist Fitness Systems General Maintenance Information

Page 17

OWNER'S MANUAL

HOIST FITNESS SYSTEMS

GENERAL MAINTENANCE INFORMATION

Links, Pull-Pins, Snap Hooks, Swivels, Weight Stack Pins:

*Check all pieces for signs of visible wear or damage.

*Check springs in snap hooks and pull-pins for proper tension and alignment.

*If the spring sticks or has lost its rigidity, replace it immediately.

Upholstery:

*To ensure prolonged upholstery life and proper hygiene, all upholstered pads should be wiped down with a damp cloth after every workout.

*Periodically take the time to use a mild soap or an approved vinyl upholstery cleaner to deter the onset of cracking or drying. Avoid using any abrasive cleaners or cleaners not intended for use on vinyl.

*Replace ripped or warn upholstery immediately.

*Keep sharp or pointed objects clear of all upholstery.

Decals:

*Inspect and familiarize yourself with any safety warnings or other user information posted on each decal.

Nuts and Bolts:

*Inspect all nuts and bolts for any loosening and tighten if needed.

*Go through a re-tightening sequence periodically to ensure that all hardware is tensioned proper.

Anti-Skid Surfaces:

*These surfaces are designed to supply secure footing and need to be replaced if they appear worn or become slippery.

Belts and Cables:

*Hoist uses only high quality belt, and mil-spec cables.

*Visually inspect the belts and cables for fraying, cracking, peeling or discoloration.

*While the machine is not in use, carefully run your fingers along the belt or cable to feel for thinning or bulging areas.

*Replace belts and cables immediately at the first signs of damage or wear. Do not use equipment until belts or cables have been replaced.

Belt and Cable Tension:

*Referring to the Owners Manual, when belts or cables are used check all bolts attachments to be sure they are properly attached.

*Check slack in cables and re-adjust cable tension if needed.

Seat Sleeves, Guide Rods:

*Wipe down adjusting tubes with a dust free rag before applying lubricant.

*Lubricate seat sleeves and Guide Rods with a Silicon or Teflon based lubricant spray.

Linear Bearings:

*Referring to the Owners Manual carefully disassemble the bearing from its housing and place a finger full of light grease (lithium, super lube, etc.) into the inside of the bearing. Using your finger, press the grease into the ball-bearings and their tracks. repeat until the ball-bearing tracks are full of grease. Insert the shaft back into the bearing and wipe off excess grease.

PLEASE KEEP THIS FOR YOUR RECORDS

CF-3461-3 ASSEMBLY

PAGE 16

Image 17
Contents CF-3461-3 Contents Tools Required InstructionsThis page WAS Intentionally Left Blank Frame Assembly Wrench Tighten Hardware 623 Decal Placement Decal Reference Dumbbell Saddle Thru Hole Part ListAbbreviations BZ = Black Zinc WZ = White Zinc HHB = Hex Head BoltBolt Sizing Chart Fhcs Shcs HHB 123 Bhcs Washer Sizing Chart 026-01M211T 1/4 Long Heavy Flanged Spacer Routine Maintenance ScheduleLinks, Pull-Pins, Snap Hooks, Swivels, Weight Stack Pins Hoist Fitness Systems General Maintenance InformationEnjoy your CF-3461-3 Hoist Fitness System Weight Training TipsWeight Training Exercise LOG Hoist Fitness Systems Limited Lifetime Warranty