Kit Number, Product | Life Fitness Digital Heart Rate Sensors

How To...REMOVE AND REPLACE THE LIFEPULSE® DIGITAL HEART RATE SENSORS

Tools Required: Phillips screwdriver, standard screwdriver, 5/64” hex key wrench

Installing the new Lifepulse digital heart rate sensors:

Kit Number

GK20-00002-0001 ( small radius )

Product

Life Fitness 9100HR and 9500HR Treadmills

Life Fitness 9500HR Cross-Trainer Total Body

Lifecycle 6500HR Exercise Bike

Lifecycle 8500 Exercise Bike

GK20-00002-0002 ( large radius )

Life Fitness 9500HR Stairclimber

Lifecycle 9500HR Exercise Bike

Lifecycle 9500HR Recumbent Exercise Bike

Step 4

Plug the Faston connector (red or white wire) to the back of the new, pre-assembled signal output sensor assembly (this will be the assembly without the screw access holes in the sensor) and locate it into position. This sensor will be the sensor on which the palm rests during use.

Step 5

Plug the Faston connector (black or green wire) to the back of the new, pre-assembled ground sensor assembly (this will be the assembly with the screw access holes in the sensor) and locate it into position. This is the sensor on which the fingertips rest during use.

Step 6

Install the two screws through the access holes in the ground sensor and torque to 5 - 7 In. Lb. .

Step 7

Repeat Steps 1 through 6 to remove and replace the second set of sensors included in the kit.

The installation is now complete.

M051-00K20-A015