Cateye MSC Download Kit Connecting with PC, Installing MSC-unit, Removing MSC-unit

Page 30

PC’s RS232C terminal (serial port)

Reference:

The battery life is approximately 50 hours (alkaline battery).

The interface unit continues to consume battery when the switch is on. When not using, turn off the switch to save the battery life.

If the battery indicator does not turn on, replace the battery with new ones.

Connecting with PC

Connect the cable of the interface unit to your PC’s RS232C terminal (serial port).

Caution:

If the cable is not securely connected to the terminal, the interface unit might fail to transmit data.

The 9-pin connector is applicable to IBM (or IBM PC/AT) computers. For other computers, an adapter may be needed.

Installing MSC-unit

Release button

Battery indicator

Hook

Stage

Power switch

Caution:

If MSC-unit is not securely connected to the contacts of interface unit, the unit might fail to download data.

1.Place your MSC-unit on the interface unit as illustrated. Hook the bottom side1 of the unit first, and then push the other side2. The unit clicks into position.

Caution:

Make sure of the position of the MSC-unit. If it is installed incor- rectly, it might cause trouble to the unit.

2.Turn on the power switch3 and see if the battery indicator turns on.

Removing MSC-unit

After download is completed, turn off the power switch and push the release-button. The MSC-unit pops out.

30e-Train Data™

Image 30
Contents Introduction For Windows 95/98/2000Meaning of the symbols in this manual About this ManualChanges from the OLD Version Contents Data Can also change the calibration of the horizontal axisBefore YOU Begin Check your packageCheck your equipment Installing e-Train Data How to uninstallTrain Data Starting e-Train Data Basic InformationOpening/Closing file Exploring the screen Menu BarScreen of memory record data Tool bar Information panel Currently shown on the graph Graph area Pop-up menu Screen of lap data Screen of heart rate target zone Specifying range Zooming graph Reducing graph ReferenceChanging horizontal axis Changing calibration in horizontal axisSmoothing graph Superimposing heart rate target zone data Superimposing lap data Viewing more than two files on the screen Cascade mode, the clicked file comes up to the front Printing data To exit e-Train Data Battery installation Downloading DataNames Connecting with PC Installing MSC-unitRemoving MSC-unit Downloading data LAP Record memory data Lap data/heart rate target zone dataQuick Reference Trouble Shooting Limited Warranty RegistrationJapan Office Upgrading your e-Train Data