Setup | Life Fitness M051-0K66-A149 specs

1.2SETUP

Read the Operation Manual before setting up the Recumbent Lifecycle Exercise Bike.

ELECTRICAL POWER REQUIREMENTS

The Recumbent Lifecycle Exercise Bike with the EngageTM Console (15” LCD) requires an AC power supply according to the electrical configurations listed in the chart below. External power is optional with the InspireTM Console (7” LCD) and the AchieveTM Console (LED).

Supply Voltage	Frequency	Rated Current
(VAC)	(Hz)	(Amps)

100	50 / 60	1.6
110	50 / 60	1.6
120	50 / 60	1.6
200	50 / 60	.8
220	50 / 60	.8
230	50 / 60	.8
240	50 / 60	.8

NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available electrical outlet, have a prop- er outlet installed by a qualified electrician.

WHERE TO PLACE THE RECUMBENT LIFECYCLE® EXERCISE BIKE

Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 3, titled Specifications, for the dimensions of the product footprint (assembled dimensions). Allow a distance of 8 to 12 inches, or 21 to 30 centimeters, between the bike and other objects or surfaces on either side. Allow a distance of 3 feet, or 1 meter, from the front or rear of the bike to any other object or surface.

HOW TO STABILIZE THE RECUMBENT LIFECYCLE® EXERCISE BIKE

After placing the bike in position, check the unit’s stability by attempting to rock it from side to side. Any slight rocking indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut

(A)with an open-end M17 wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the stabilizer bar.

CHECK FOR BATTERY POWER

The Achieve (LED) and Inspire (7” LCD) consoles are powered by a rechargeable 6-volt battery. Check the battery by

pressing and holding the power on/off key. The console should beep and light up. The Message Center on the Achieve console will display a prompt to set up a workout. The Inspire console will show a message on the LCD indicat- ing it is initializing (for up to 2 minutes). If a prompt doesn’t appear or initializing doesn’t begin, mount the Recumbent Lifecycle Exercise Bike and begin pedaling. The console should light up and programming a workout should be possible. Pedal for 20 minutes at 40 rpm or faster during a workout to charge the battery. The pedal action during workouts keeps the battery charged. If the Lifecycle Exercise Bike is externally powered by the 36V DC power supply, battery maintenance is auto- matic and pedaling is not required.