Burley 09 Encore, 09 d'lite, 09 Solo installation instructions Contents, Roll Bar Installation

Page 1

Installation Instructions

for ‘09 d’lite, Encore® and Solo(Euro) Child Trailers

Installation Instructions

for ‘09 d’lite, Encore® and Solo(Euro) Child Trailers

Contents:

(1)Burley Owner’s Instruction and Safety Manual

(1)Hitch

(1)Clear light with batteries included

(1)Red light with batteries included

(2)Phillip Pan screws

(2) Brackets for lights

(1)Wheel guard assembly:

(2) wheel guards

(4) screws

(1) 5mm hex key wrench

Tools Required: Phillips screwdriver 4mm hex wrench

10mm or open end wrench

Note: Consult your Burley Owner’s Instruction and Safety Manual for wheel guard and hitch installation instructions.

Roll Bar Installation

1.If handle bar receivers are already installed, loosen and remove handle bar knobs and outer handle bar receivers.

Figure 1

2.Using wrench, loosen and remove lock nuts and screws from handle bar receivers.

3.From trailer front, slide roll bar into upper handle bar receivers, with curved front extending above trailer body.

4.Match holes in roll bar and inner handle bar receivers, re-install screws and tighten lock nuts.

5.Replace outer handle bar receivers and tighten knobs.

 

of

Trailer

Front

 

 

Screws

 

 

Roll Bar

 

Rear Assembly

Lock Nuts

Frame

Handle bar

Knob

Inner Handle bar

Receiver

Outer Handle bar

Receiver

Contents:

(1)Burley Owner’s Instruction and Safety Manual

(1)Hitch

(1)Clear light with batteries included

(1)Red light with batteries included

(2)Phillip Pan screws

(2) Brackets for lights

(1)Wheel guard assembly:

(2) wheel guards

(4) screws

(1) 5mm hex key wrench

Tools Required: Phillips screwdriver 4mm hex wrench

10mm or open end wrench

Note: Consult your Burley Owner’s Instruction and Safety Manual for wheel guard and hitch installation instructions.

Roll Bar Installation

1.If handle bar receivers are already installed, loosen and remove handle bar knobs and outer handle bar receivers.

Figure 1

2.Using wrench, loosen and remove lock nuts and screws from handle bar receivers.

3.From trailer front, slide roll bar into upper handle bar receivers, with curved front extending above trailer body.

4.Match holes in roll bar and inner handle bar receivers, re-install screws and tighten lock nuts.

5.Replace outer handle bar receivers and tighten knobs.

 

of

Trailer

Front

 

 

Screws

 

 

Roll Bar

 

Rear Assembly

Lock Nuts

Frame

Handle bar

Knob

Inner Handle bar

Receiver

Outer Handle bar

Receiver

FIGURE 1: Roll Bar Installation

FIGURE 1: Roll Bar Installation

Image 1
Contents Roll Bar Installation ContentsLocking Quick Release Wheel Installation Operation Light InstallationBurley Design