Figure a

5.Use the remaining Draw Strings to secure the rest of the Fabric Cover (1) to the Main Support Frame (3) and Side Frames (2). (See Assy. Diagram.)

6.Remove the Bolt (11), Flat Washer (7), and Wing Nut (10) from one end of the Rear Cross Bar (12). (See Figure A and Assy. Diagram.)

7.With assistance, position the Hunting Shelter against the trunk of a tree. Adjust the Rear Cross Bar (12) to fit firmly against the tree trunk. Then secure the Hunt- ing Shelter to the tree trunk by re-installing the Bolt (11), Flat Washer (7), and Wing Nut (10) on the Rear Cross Bar. (See Figure A and Assy. Diagram.)

8.NOTE: Make sure both Bolts (11), Flat Washers (7), and Wing Nuts (10) on the

Rear Cross Bar are firmly tightened.(See Figure A and Assy. Diagram.)

9.Attach the Side Cover (18) to the Side Frame (2) using the 8 Hooks (17). See diagram on page 7.

REAR CROSS BAR (12)

BOLT (11)

FLAT WASHER (7)

WING NUT (10)

10.Adjust the height of the shelter so the Side Cover touch the ground. See cover page photo.

11.Attach the bottom of the Side Cover (18) to the ground using the U-Shaped land- scape Staples (19). See Parts List and Assembly Diagram on page 6 and 7.

REV 08e

SKU 96529

For technical questions, please call 1-800-444-3353.

Page 5