Bushnell 98-2307/10-10 instruction manual Using the Mini Tripod, Not overtighten

USING the MINI TRIPOD		E
•	Loosen the knob (A) at the base of the collapsible		D
	tripod legs. Unfold the legs fully and set the tripod on a			F
	stable, level surface such as a table or the ground.
• Make sure the upper section of the tripod is level and					C
	securely attached to the top plate (B) of the lower
			B
	section, by tightening the C-clamp bolt (C).
• Turn the mounting screw knob (D) to attach the scope’s
	mounting base securely to the tripod platform (E) (do
	not overtighten).
• Twist the pan/tilt handle (F) counter-clockwise to		A
	loosen it, tilt the tripod head until the mounting
	platform is level with the ground, then twist the handle
	clockwise to tighten it.		Note: appearance and
•	To tilt the scope vertically, twist the pan/tilt handle
			features of tripod are
	counter-clockwise to loosen it first, then tilt the tripod		subject to change.
	head up or down. To pan the scope left or right, loosen

the pan lock knob first, then use the pan/tilt handle to rotate the tripod platform.

•The top section of the mini tripod may also be used as a car window mount. Loosen the C-clamp bolt (C), and remove the top section. Roll down your window partially, leaving enough of it up to place the C-clamp on, with the bolt knob facing you. Tighten the knob to secure the mount in place, being careful not to cause damage to the window (avoid using the mount on windows with significant curvature).