Trek Bicycle Computer manual To replace the computer battery

Page 23

To replace the computer battery

1.Remove the computer from its base.

2.Identify the battery cover, with its deep slot (a similar battery cover is found on the back, or skin-side, or the heart rate strap).

3.Insert a large coin into the slot and rotate in a counter-clockwise direction about one-quarter turn (Figure 18).

4.Lift the battery cover, exposing the battery.

Be careful to avoid losing the rubber O-ring seal.

5.Remove the old battery.

It may be possible to shake the battery out. Otherwise, carefully pry the battery up with a thin tool or knife blade.

6.Insert the new battery with the ‘cross’ and identifying label pointing up (Figure 19).

7.Replace the battery cover (and O-ring seal) and turn one-quarter turn clockwise.

Figure 18- Removing battery cover

Figure 19- The ‘cross’ on the bat- tery points up

Replacing the battery

21

06 Incite ACH 07_13.indd 21

7/14/06 7:26:07 AM

Image 23

Contents Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite ACH and ACH DigitalContents Watch the road when Safety and general guidelinesFunction Explanation FunctionsPage Backlight Mount InstallationStem mount Handlebar Speed sensor Placing the computer on the handlebar To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet and sensors To install the wheel magnet0mm To install the sensorMagnet must pass across the line on the sensor Figure Tighten the nylon ties and trim the excess length Figure Positioning of the heart rate strap Mode Scroll Set Easy setup ReSetUsing the buttons Size, see pages To set the wheel sizeHour flashes To set Units and TimeFlashes PAIR? see next section Pairing ACH Digital onlyTo Pair the computer Screen will show one of two thingsMove away from other computers, cell phones, etc PAIR? signal appearsReplace the battery in the sensor- see Screen changes to PairTo start the trip modes ReStart- Getting ready to rideTo ReStart set the Trip data to zero Removing the computer from the computer base Changing mode Using the computer in wet weather Additional informationTroubleshooting Low battery icon Replacing the batteryBe careful to avoid losing the rubber O-ring seal To replace the computer batteryAdvanced features Screen returns to TRP UnitsTo set Units KMH appearsScreen returns to Time ClockTo set Clock Appears instead of Zero, shows a time StopwatchTo start the stopwatch Computer returns to SPD Wheel sizeIf PAIR? appears, see Number representing wheel size appearsFirst digit flashes To set a custom wheel sizeWheel selection icon appears Number representing tire size appearsTo measure rollout for wheel size Computer returns to the TRP screen To select the wheel sizeIf the PAIR? screen appears, see SpeedTo view speed data Next digit flashes OdometerTo set Odometer total TTL First digit of five flashesIf the Pair screen appears, see CadenceTo view cadence data To set current altitude CUR AltitudeTo view altitude data Computer returns to the Altitude TTL screen To manually set Altitude total TTLComputer returns to the Altitude CUR screen To view grade data GradeTo view heart rate data Heart rateScreen returns to Zone Heart rate zoneTo set heart rate zones Down arrow appears, and the first digit flashesThis warranty does not cover Limited WarrantyThis warranty covers