Trek 2.0 owner manual Trouble Shooting

12/24 – hour Clock

Under any display mode, press R button for 1 second. Clock time will displayed. Re-press either L or R button to return to “Odometer (ODO)” mode. Refer to the instruction of “Setting clock time” for 12/24- hour selecting and resetting.

Auto Start/Stop

All functions (ODO, DIS, AVS, RT, MAX) automatically start when a signal is detected, and stop when there is no signal detected. The Clock function is the only exception.

Auto Scan

Under any display mode, press the L button to enter the auto scan function. All display modes will cycle with each display mode lasting 3 seconds. Press L or R button to return to the current display mode in use.

Auto Power Saving	6
	fig

In any display mode, the unit will go into power-save mode after the computer has not received any input signal for 10 minutes. The last mode in use will disappear and be saved. The time will display automatically as fig.

6.The Current Speed/Odometer mode will resume once any button is pressed or you begin pedaling.

TROUBLE SHOOTING

The following situations do not indicate malfunction of the computer. Check the following before taking unit for repair.

Trouble	Check Items	Remedy
Missed setting for speed		Execute “All Clear”
scale or wheel		operation Re-install battery.
circumference
The entire liquid crystal	Was it left for a long time	It returns to normal state
screen is dark and unusual	under direct sunlight?	by leaving it in the shade.
display is seen.		No adverse effect on data.
Display response is slow.	Is it at a low temperature	It returns to normal state
	under 32.0F (0.8C)?	when temperature rises.
Incorrect data appears.		Re-insert the battery
No Display	Has the battery in the main	Replace the battery with a
	unit worn out?	new one. (3V/DC)
Current Speed does not	Is there anything on the	Wipe the contact clean
appear.	contact of the main unit or
	on the bracket?

Auto Clear/Reset

Under any display mode, press L & R buttons for 10 seconds, km or Mile will flash quickly, then all data stored in memory will be erased except Odometer data. All displays will illuminate for 1 second, then the km/h symbol displayed alone. This operation should only be executed after replacing the battery or when you change different bikes and need to program Odometer data or when an irregular display of the information occurs due to static electricity, etc. Since all the memories are erased, reset the main unit again according to “Preparation”.

Are the wheel sensor and magnet too far apart?

Are the marking lines of the wheel sensor and the center of the magnet aligned?

Is the wire broken?

Refer to “installation fig. 8” and re-adjust correctly.

Refer to “installation fig. 8” and re-adjust correctly.

Replace the bracket wire

&wheel sensor with a new one.

Page 8 Page 9