S T E P 1
S T E P 2
S T E P 1 O R A N G E B A G
•Place the rubber console mast boot on the end of the console mast.
•Connect the wire tie that exits the bottom of the console mast to the bundle of wires that comes from the bracket at the top of the frame. Pull the wire tie and wire harness up through the console mast while at the same time inserting the console mast into the frame bracket.
•Secure the console mast to the frame with two capscrews (M10 x 70L). Tighten with the 8MM
•Stabilize the console mast to the frame with the socket head cap screw (M10x70L). Tighten with the 10MM
•Slide the rubber boot down the console mast and snap it in place so it integrates with the side covers.
S T E P 2 | B L U E B A G |
• Place a wavy washer (M20x30x1.5t) on the axle located under the foot plate of the right lower link arm.
•Slide the axle of the lower link arm into the bracket located on the top of the right pedal arm. Secure lower link arm by attaching the pedal support bracket and screw (M8x15L) to the end of the axle. Secure the outside holes in the bracket to the footplate
with two screws (M8x10L). Tighten screws with the 5MM Allen wrench.
•Repeat the same steps on the left side.
5