JVC CA-MXJ150R manual Common Operations, Setting the Clock

English

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built in this unit.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you want to stop clock setting, press CLOCK/TIMER once or wait until the time limit of 15 seconds comes.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER until the “CLOCK” is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

Clock time CLOCK

REC TIMER

If there is a power failure

The clock loses the setting and is reset to “0:00.” You need to set the

1 Press CLOCK/TIMER twice.

The “CLOCK” appears on the display.

2 Press PROGRAM/SET.

The hour digits start flashing on the display.

3 Press 4or ¢to adjust the hour, then press

PROGRAM/SET.

After hour digits are set, the minute digits start flashing on the display.

CLOCK /TIMER

PROGRAM/SET

clock again.

Turning On the Power and Selecting the Sources

When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).

To listen to the FM, MW, or LW broadcasts, press FM/

AM. (See page 11.)

To play back CDs, press CD 6. (See pages 14 and 15.) To play back tapes, press TAPE 3. (See page 16.)

To select the external equipment as the source, press AUX.

AUX FM/AM CD TAPE

PROGRAM/SET

To turn on the unit without playing, press

(standby/on) so that the STANDBY lamp

STANDBY

4 Press 4or ¢to adjust the minute, then press

PROGRAM/SET.

	PROGRAM/SET
5 Press CLOCK/TIMER twice to	/TIMER
	CLOCK
finish the clock setting.

goes off.

To turn off the unit (on standby), press

STANDBY

(standby/on) again so that the STANDBY lamp lights up.

A little power is always consumed even while the unit is on standby.

To check the clock time		To switch off the power supply completely, unplug the AC
Press CLOCK/TIMER while playing any source.	/TIMER	power cord from the AC outlet.
	CLOCK
The clock time appears on the display
for a while.
		When you unplug the AC power cord or if a power
		failure occurs
		The clock is reset to “0:00” right away, while the tuner preset
		stations (see page 11) will be erased in a few days.

– 9 –