STEP 3: CONNECTING ARMS AND REAR RAIL ASSEMBLY
∙Align the hole in the rod end bearings at the ends of the Connecting Arms (7&8) with the hole in the bracket of the Swing Arms. There is a sleeve spacer already installed in the rod ends and held in place with a twist tie; make sure these spacers do not fall out during assembly. The rod end bearing should be positioned to the inside of the swing arm brackets. Install two 5/16" Hex Head Bolts (71) through the left and right swing arm brackets and the rod end and secure with 5/16" Flat Washers (98) and 5/16" Nuts (105).
∙Install the two Rear Rail Tubes (16) to the rear end of the Main Frame (1) and secure with two 3/8 x
∙Install the Rail Stabilizer (15) between the rearward ends of the Rail Tubes (16) and secure with four 3/8 x
10 | EL255 Elliptical |
|