Spirit XE400 owner manual Connecting Arm Assembling

Page 13

STEP 3: Connecting Arm Assembling

1.Untie the wire holding the sleeve spacer (22) in place on the rod-end bearings, located on the ends of the connecting arms (8&9). Align the hole in the rod ends with the hole in the brackets of the left and right Handle Bar (10&11). The rod end should be on the inner side of the Handle Bar bracket. Secure with A 5/16x1-1/4 Hex Head bolt, 5/16x20mm Flat Washer (100) and 5/16 Nylon Nut (91) by using 13/14 mm Wrench (124) and 12mm Wrench (129).

10

11 79

22

100

91

91	100
	22
8	79
	79

9

12	XE Series Elliptical

Image 13

Contents Page Table of Contents Product Registration Important Safety Instructions Grounding Instructions Important Electrical InformationImportant Operation Instructions Assembly Pack Check List Step Tools Incline Rail Assembly and Console Mast Assembly Instructions XE400XE Series Elliptical Handlebar Assembly Connecting Arm Assembling Plastic Parts Assembling XE Series Elliptical Footpads FeaturesIncline XE400 Console Power upBasic information Quick StartProgramming the console Entering/Changing SettingsManual Preset ProgramsWork Profile Incline Profile Work Profile Incline Profile Cardio Fat BurnWork Profile Incline Profile Strength Work Profile Incline Profile IntervalCustom User Defined Programs Work Profile Incline Profile Programming Preset ProgramsXE Series Elliptical XE Series Elliptical Rate of Perceived Exertion Erratic Operation Using a Heart Rate TransmitterHeart Rate Control Program 1 & 2 HR 1, HR 2 operation Maintenance Menu in console software MaintenanceElliptical Warranty Manufacturer’s Limited Warranty