Assembly Instructions

STEP 8

To assemble the STATIONARY HANDLEBAR(10), run the PULSE SENSOR WIRES(64) through the hole on the UPRIGHT(2) and through the opening on the top. Attach the STATIONARY HANDLEBAR(10) to the UPRIGHT(2) with BUTTON HEAD BOLTS(M8x1.25x15mm)(67) and WASHERS(M8)(68).

STEP 9

Install two AA batteries into the METER(15), the batteries are not included. See page 14 for detailed battery installation instructions. Plug the EXTENSION WIRE(58) and PULSE SENSOR WIRES(64) into the METER(15), and push the excess wires back into the UPRIGHT(2). Slide the METER(15) onto the top of the UPRIGHT(2).

NOTE: Be careful not to damage the wires when attaching the METER(15) to the UPRIGHT(2).