Assembly

Getting Started - The CardioZone E-CZ200 Elliptical will require some assembly. Unpack the box in a clear area. Remove packing material. Do not dispose of packing material until assem- bly is complete and unit is working properly. Place the unit on a clean level surface for assem- bly. Make sure there is easy access to an electrical outlet. Before assembling, the unit should be placed as close as possible to its final location. Locate all hardware bags, Labeled Figure

1 through Figure 9, with the exception of Figure 8. If you are missing any bags, please call CardioZone at 1-888-340-0482. Tools have been provided to assist with product assembly.

Figure 1

Locate bag labeled Figure 1. Locate console tube. Attach console tube to main frame. Slide tube down into main frame. Connect upper console wire to lead wire assembly. Secure using three M10*80

mmhex head screws extending through the frame and console tube, three 10x20 washers and three crown nuts, M10*1.5. Use three M10*120 hex screws to secure through the front of the console tube and main frame.

Note: Ensure that all wires are secure inside console. Be careful not to pinch wires.

Note: Do not tighten Screws until you have fully completed Figure 2.

Figure 1
	CONSOLE TUBE
	UPPER CONSOLE WIRE
LEAD WIRE ASSEMBLY
	CROWN NUT, M10*1.5
M10*80 HEX SCREW
10*20 WASHER	M10*120 HEX SCREW
10*20 WASHER