Assembly
FIGURE 5
Step 1:
Install the left sleeve (6a) to the axle on the upright tube
(3)and secure with washer (46), nut (45), and nut cap
(44).Connect the pulse wire
(42)with the pulse wire (87). Connect pulse wire (88) to the second connector on the pulse wire (87). Connect the upper handlebar (7a)
to the lower left handlebar (6a) with carriage bolts (62), washers (63) and cap nuts
(64).Attach the pedal tube to the lower left handlebar (6a) with nut caps (67). Finally, insert plastic cap (85) into the opening as shown. Repeat on right side.
FIGURE 6
Step 1:
Connect the sensor wire (72) and the pulse wires to the con- sole (9). Attach the console
(9)to the top of the upright tube (3) and secure it using screws (69) attached to the console.
Figure 5
|
|
| 7a |
| 88 |
|
|
|
| 85 | |
| 64 | 63 | 67 | ||
|
| ||||
|
|
| 87 | ||
|
|
|
| ||
|
|
|
|
| |
44 | 45 | 46 | 42 |
| |
|
| ||||
|
|
|
| ||
|
|
|
|
| |
|
|
|
| 62 | 3 |
6a |
|
|
|
| |
| 362771 |
| 40 |
|
|
Figure 6 | 9 |
|
72
69
7b
6b
3