ASSEMBLY
Opening Stroller
To open stroller:
•Stand stroller upright and pull out on Red Frame Latch while opening.
•Spread handle and rear legs until both Fold Locks “click” into position.
Red Frame
Latch
Fold
Locks
Rear Axle and Wheels
To attach rear axle and brakes:
• Remove axle protectors from ends of axle and discard.
• With stroller laying face down on floor, slide brake lever brackets onto rear legs until 
they “click” in place.
NOTE: Brake levers must face rear of stroller.
To attach wheels to rear axle:
•Slide Wheel onto end of Axle with brake ribs facing in.
•Push Wheel Retainer onto end of Axle. Make sure large end of Wheel Retainer is towards Wheel. Wheel Retainer should snap into groove on end of Axle.
•Snap wheel Retainer Cap over Wheel Retainer.
•Line up slot in Hub Cap with rib on Wheel and snap Hub Cap in place.
Axle
Hub
Cap
Retainer Wheel Wheel
Cap Retainer
CAUTION:
•Failure to install retainer cap may cause wheels to come off of stroller.
•After wheel assembly is complete, pull on wheels to check that they are locked into place.
WARNING
Prevent a possible choking hazard, discard axle protectors and polybag which contained rear wheel parts.
3