Life Fitness M051-00K61-C131 manual Screws 2. Tighten the Screws securely

8.Attach the 4-PIN(4P) and 16-PIN(16P) CONNECTORS to the corresponding JACKS on the back of the CONSOLE ASSEMBLY (4).

9.Feed any excess WIRE HARNESS (E) down into the CONSOLE

SUPPORT ASSEMBLY (7). Secure the CONSOLE ASSEMBLY (4) to the CONSOLE SUPPORT ASSEMBLY using four PHILLIPS PAN HEAD

SCREWS (2). Tighten the SCREWS securely.

CAUTION: Do not over-tighten the PHILLIPS PAN HEAD SCREWS (2).

	4P
	16P
21	4
19
	23

	CAUTION: Be careful not to pinch the WIRE HARNESS (E) when	2	3
	assembling the CONSOLE ASSEMBLY (4) to the CONSOLE SUPPORT
	ASSEMBLY (7).
10.	Locate and install the CONSOLE SUPPORT CAP (19) onto the	7	17
	CONSOLE SUPPORT ASSEMBLY (7) as shown using four CAP	E	20
	SCREWS (21).
11.	Place the BACK MONOCOLUMN COVER (6) over the PIVOT SHAFT (H)	1
	at the top of the MONOCOLUMN (F).

12. Place the FRONT MONOCOLUMN COVER (5) on the opposite side of	8
the BACK MONOCOLUMN COVER (6) to cover the PIVOT SHAFT (G)	F
and CONSOLE SUPPORT ASSEMBLY MOUNTING SCREWS. Interlock the
top tabs and use two PHILLIPS PAN HEAD POINTED SCREWS (3) to
secure the bottoms of the MONOCOLUMN COVERS together.
Tighten the SCREWS securely.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD POINTED
SCREWS (3).
13. Locate one FRONT ROCKER COVER (13) and one BACK ROCKER	13
COVER (14). Position the FRONT ROCKER COVER over the user
side of the left end of the PIVOT SHAFT (H) (as shown) making	G
sure that it interlocks with the MONOCOLUMN COVERS (5 & 6).
Place the BACK ROCKER COVER over the opposite side of the left	14
end of the PIVOT SHAFT in the same manner. Secure the COVERS	5
using three PHILLIPS PAN HEAD POINTED SCREWS (3). Repeat the
	H
procedure reversing front and back for the user right end of the
	6
PIVOT SHAFT.	3

F

CAUTION: Do not over-tighten the PHILLIPS PAN HEAD POINTED

SCREWS (3).

13

3

22

14

6