Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the	1
treadmill to the upright position as shown at the right.	1
treadmill to the upright position as shown at the right.
While a second person tips the treadmill to one side
and holds it, insert one of the Extension Legs (102) into
the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs				102
(102) are resting flat on the floor.				102
(102) are resting flat on the floor.
				99
2. With the help of a second person, carefully lower the	2
treadmill frame and then tip the Uprights (69) down as	2
treadmill frame and then tip the Uprights (69) down as
shown. Make sure that the Extension Legs (102) remain
in the Uprights.
Attach each Extension Leg (102) with two of the four 3/4Ó		99
Attach each Extension Leg (102) with two of the four 3/4Ó
Screws (100) as shown.		Frame
With the help of a second person, carefully tip the				69
Uprights (69) back to the vertical position.				69
	69			100
Note: One replacement Base Pad (99) may be included.	69			102
Note: One replacement Base Pad (99) may be included.				102
Use the extra Pad if one becomes worn or needs to be re-	99	100
placed.		100
		102


3. There may be a plastic tie inside the post on the right	3
Upright (69). If there is, insert the plastic tie through a	3
Upright (69). If there is, insert the plastic tie through a
Handrail Extension (66) and insert the Handrail Extension		Tab	76	81
into the post as shown. Make sure that the indicated holes		Tab	76
are on top. Tap the Handrail Extension with a rubber mallet			67	78
			Holes	78

to fully insert it. Attach the Handrail Extension with two 1/2Ó		Cutout
		Cutout
Screws (67) as shown.				69
		75		69
Identify the Right Foam Grip (75), which has a large cutout		75
Identify the Right Foam Grip (75), which has a large cutout			66	Post
in the left side for the Pulse Bar (76). Slide the Right Foam				Post

Grip as far as possible onto the post on the right Upright		Tie
(69). Make sure the tab on the Foam Grip inserts into the
Console Base (81). It may be helpful to use soapy water on
the Handrail Extensions (66).