ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-
driver 
and rubber mallet 
.
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the treadmill to the upright position as shown.
Insert one of the Extension Legs (55) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (44) is on the bottom. If necessary, tip the Uprights (64) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
2.With the help of a second person, carefully lower the Uprights (64) as shown. Note: It may be helpful to place your foot on a Wheel (58) as you tip the Uprights. Make sure that the Extension Legs (55) remain in the Uprights.
Attach each Extension Leg (55) with an Extension Screw (35), a 1” Screw (86), and a Base Pad (44) as shown.
Note: One replacement Base Pad (44) may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad.
1 |
|
|
|
|
| 64 |
|
|
|
| 55 |
|
| 44 |
|
2 |
|
|
|
|
|
| 35 |
|
| 55 | 86 |
|
|
| |
64 | 35 |
| 44 |
55 | 86 |
|
|
44 |
|
|
|
58 |
|
|
|
35 |
| 86 |
|
6