TROUBLESHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on posi- tion.
PROBLEM: The power turns off during use
c |
|
Tripped | Reset |
d | On |
| |
| Position |
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. Make sure that the on/off switch is in the on position.
e. If the treadmill still will not run, please call our
PROBLEM: The speed display on the console does not function properly
SOLUTION: | a. Remove the key and | UNPLUG THE POWER CORD | . | a | 64 | 37 |
| Carefully lower the Uprights (64) to the floor. Remove |
| ||||
|
|
|
|
| ||
| the three indicated Small Screws (37). |
|
|
| 37 | |
|
|
|
|
|
| |
|
|
|
|
| 37 |
|
| Raise the Uprights (64) to the vertical position. Pivot |
|
|
| 64 | |
| the Hood (1) off. |
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| 1 |
23