ProForm 831.29604.2 specification

2.Attach a Wheel (66) to the base of the Uprights (69) with a Wheel Bolt (64) and a Nut (13) as shown. Do not overtighten the Wheel Bolt; the Wheel should turn freely.

With the help of a second person, carefully tip the tread- mill onto its other side. See assembly step 1, and attach the other Extension Leg (63) and the remaining two Base Pads (57). Then, attach the other Wheel (66) as described above.

With the help of a second person, carefully tip the tread- mill down so the Uprights (69) are in a vertical position.

3.Insert the tab on one of the Handrail Brackets (21) into the slot in the right Upright (69). Attach the Handrail Bracket with a 3/4” Screw (2) and a Small Star Washer (24).

Attach the other Handrail Bracket to the left Upright (not shown) in the same way.

4.If there is a board between the Uprights (69), remove the board and the two bolts. Discard the board and the bolts.

Identify the Right Handrail (72), which has a large hole in the left side. Cut the plastic tie securing the Upright Wire

(42)to the right Upright (69). Feed the Upright Wire into the hole in the bottom of the Right Handrail and out of the large hole in the side. Note: It may be helpful to use needlenose pliers to pull the Upright Wire out of the hole.

Press a Handrail Cap (16) onto the lower end of the Right Handrail (72) as shown. Set the Right Handrail on the right Upright (69) while sliding the lower end of the Right Handrail onto the right Handrail Bracket (21). Finger tighten a Handrail Bolt (37) with a Handrail Star Washer (95) into the Right Handrail and the right Upright. Next, attach the lower end of the Right Handrail with a 3/4” Tek Screw (58) and a Small Star Washer (24). Then, tighten the Handrail Bolt.

Attach the Left Handrail (71) in the same way. Note: There is not an upright wire on the left side.

2		64
		64
	69	66
	69
		13
3	69
	69

Slot

	21
	24
	2
4
37		71
37
95
		42	Hole
	69	37
	69
		95
		72
24			69
	16
		16
58
		24
	58		21
	58