CONSOLE DIAGRAM
Note:
If
there
is
a
thin
sheet
of clear
plastic
on
the
face
of the
console,
remove it before operating the console.
CAUTION: Before operating the console, read the following precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip (see the drawing at the lower right) while using the treadmill. When the key is removed from the console, the walking belt will stop.
•Adjust the speed in small increments.
•The training zones marked beside the speed control are general guidelines only. See page 14 for more information.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
BATTERY INSTALLATION
The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. Open the battery cover as shown in the drawing at the upper right. Insert two batteries into the battery compartment, making sure that the negative
Battery |
|
Cover |
|
Batteries | Battery |
| Cover Tab |
are touching the springs in the battery compartment. Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot |
|
|
|
|
|
|
|
|
|
|
|
| |
rails of the treadmill. Find |
| Clip |
|
|
|
|
the clip attached to the key, |
|
|
|
|
|
|
|
|
|
|
|
| |
and slide the clip onto the |
|
|
|
|
|
|
|
|
|
|
|
| |
waistband of your clothing. |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
Follow the steps on page 9 to operate the console.
8