CONSOLE DIAGRAM
LED Track
Note:
If
there
is
a
thin
sheet
of
clear
plastic
on
the
face
of the
console,
remove it before operating the console.
CAUTION: Before operating the console, read the following precautions.
¥Do not stand on the walking belt when turning on the power.
¥Always wear the clip (see the drawing at the lower right) while using the treadmill. When the key is removed from the console, the walking belt will stop.
¥Adjust the speed in small increments.
¥The training zones marked beside the speed control are general guidelines only. See page 14 for more information.
¥To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
Battery |
|
Cover |
|
Batteries | Battery |
| Cover Tab |
that the negative (Ð) ends of the batteries are touching the springs in the battery compartment. Close the bat- tery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.)
BATTERY INSTALLATION
The console requires either two or three "AA" bat- teries (not included). Alkaline batteries are recom- mended. Open the battery cover as shown in the draw- ing at the upper right. Insert the required number of batteries into the battery compartment, making sure
Next, step onto the foot |
|
|
|
|
|
|
rails of the treadmill. Find |
| Clip |
|
|
|
|
|
|
|
|
| ||
the clip attached to the key, |
|
|
|
|
|
|
and slide the clip onto the |
|
|
|
|
|
|
|
|
|
|
|
| |
waistband of your clothing. |
|
|
|
|
|
|
|
|
|
|
|
|
Follow the steps on the page 9 to operate the console.
8