To stop the walking belt, press the Stop button. The Time/Distance display will begin to flash.
Note: During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and align it if necessary (see page 15).
3 Change the incline of the treadmill as desired.
To change the incline of the treadmill, press either of the Incline buttons until the desired incline level is reached.
4 Follow your progress with the three displays.
Fat Calories/Calories/
Pulse
proximate numbers of fat calories and calories you have burned (see FAT
BURNING on page 17). The display will change
from one number to the other every few seconds, as shown by the mode indicators. This display will also show your heart rate when you use the pulse sensor (see step 5).
Time/Distance display—This display
shows the elapsed time and the distance that you have walked or run. The display will change
from one number to the
other every few seconds, as shown by the mode indicators. Note: When the Stop button is pressed, this display will flash.
Speed
Note: The console can display speed and dis- tance in either miles or kilometers. To change the unit of measurement, hold down the Stop button
while inserting the key
into the console. An “E” for English miles or an “M” for metric kilometers
will appear in the Speed display. Press the Speed
+ button to change the
unit of measurement. When the desired unit of measurement is selected, remove the key and then reinsert it.
To reset the displays, press the Stop button, re- move the key, and then reinsert the key.
5 Measure your heart rate if desired.
To measure your heart rate, stand on the foot rails and place your thumb on the pulse sen- sor. Do not press too hard, or the circulation in your
thumb will be restricted and your pulse will not be detected. After a few seconds, the heart- shaped indicator in the Fat Calories/Calories/ Pulse display will begin to flash, and then your heart rate will be shown. Hold your thumb on the pulse sensor for about 15 seconds for the most ac- curate reading.
If the displayed heart rate appears to be too high or too low, or if your heart rate is not displayed, lift your thumb off the pulse sensor for a few seconds. Then, place your thumb on the pulse sensor as de- scribed above. Remember to stand still while mea- suring your heart rate.
6 Whenkey. you are finished exercising, remove the
Step onto the foot rails, press the Stop button, and remove the key from the console. Keep the key in a secure place. Move the reset/off circuit breaker to the off position and unplug the power cord.
12