THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor provides
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (40) and the Access Door (76).
| 116 |
101 |
|
A |
|
Cylinder | 76 |
| 40 |
2.Remove the paper from the adhesive pad on the back of the receiver (A). Orient the receiver so the small cylinder is near the lower edge of the re- ceiver and is facing the Console Back (116) as shown. Firmly press the receiver onto the indicated corner of the Access Door (76). Connect the wire on the receiver to the Pulse Wire (101) extending from the Console Back.
3.Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (40). Note: The other wires included with the receiver may be dis- carded.
24