ProForm PFBE30790 user manual

Page 5

3.Identify the Right Upright (2) by noting the posi- tions of the adjustment brackets and the bolt holes near the lower end. Attach the Right Upright to the indicated Stabilizer (3) with two M10 x 95mm Bolts (49), two 10mm Washers (34), and two 15mm x 70mm Spacers (39). Do not tighten the Bolts yet.

Press a 76mm Slotted Endcap (16) into the bot- tom of the Right Upright (2); it may be necessary to turn the Slotted Endcap so it fits around the 15mm x 70mm Spacers (39).

Attach the Left Upright (not shown) to the other Stabilizer (not shown) in the same manner.

4.Insert the Right Barbell Lock Pin (38) through the welded tube on a Weight Rest (1). Tighten an M10 Nylon Locknut (35) onto the Right Barbell Lock Pin.

Attach the Left Barbell Lock Pin (28) to the other Weight Rest (1) in the same manner.

Slide a 76mm Plastic Bushing (14) onto each Weight Rest (1). The Plastic Bushings must be turned as shown.

5.Insert a 32mm Square Endcap (40) into each end of the Adjustment Bar (9). Set the Adjust- ment Bar in the lowest set of adjustment brackets on the Right and Left Uprights (2, 26).

Refer to step 2 and tighten the six M10 Nylon Locknuts (35) used in that step. Do not over- tighten the Nylon Locknuts. Next, refer to step 3 and tighten the four M10 x 95mm Bolts (49) used in that step. Do not overtighten the

Bolts; the Uprights will be damaged and you will not be able to fully insert the Weight Rests (1) into the Uprights.

Insert the Weight Rest (1) with the Right Barbell Lock Pin (38) into the Right Upright (2). Press the 76mm Plastic Bushing (14) firmly into the top of the Right Upright. Insert an Adjustment Pin (17) through the holes in the Right Upright and the Weight Rest (1).

Attach the other Weight Rest (1) to the Left Upright (26) in the same way. Make sure that both Weight Rests are at the same height.

3

 

 

 

Adjustment

 

 

Brackets

2

 

 

 

Bolt

 

34

Holes

3

49

 

 

 

39

 

16

 

 

4

 

 

38

35

28

 

1

 

 

14

 

5

 

40

 

 

 

9

 

38

 

1

 

 

1

40

 

 

 

14

 

 

 

 

26

17

Adjustment

 

Brackets

 

2

 

5

Image 5
Contents Customer HOT Line QUESTIONS?Model No. PFBE30790 Serial No Important Precautions Table of ContentsBefore YOU Begin As shown. Do not tighten the Nylon Locknut yet AssemblyFollowing Tools not Included are Required for Assembly Page Refer to the inset drawing. Press a 25.4mm Refer to the inset drawing. Insert the WeightPre-assembled at the factory Nylon LocknutDo not overtighten the Nylon Locknut Adjusting the Weight Rests HOW to Adjust the Weight BenchAdjusting the Backrest Attaching the Preacher Curl PAD Using the LEG LeverQty Description Part LISTÑModel No. PFBE30790Exploded DRAWINGÑModel No. PFBE30790 Page Page Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty