English
Listening to the sound of | Auto Standby |
other audio device |
|
Connect the other audio device to this system in advance (A page 11).
1 Press AUX.
The source changes to AUX.
2 Play the other audio device.
For details, refer to the manual of the device connected.
3 Adjust the volume and the sound quality of the system (A page 17).
Adjust the sound input level of the audio device
You can adjust the sound input level of another audio device connected to the AUX jack.
1 Press AUX.
The source changes to AUX.
2 Hold down MEMORY until an input level is displayed.
Each time you hold down the button, it switches as follows:
LEVEL 1: Select this normally.
LEVEL 2: Select this when the input level from the other device is too high and the sound is distorted.
The initial setting is “LEVEL1”.
If there is no operation for 3 minutes while the disc is stopped, the power will be automatically turned off.
1 Press A.STANDBY during playback or while the disc is stopped, or no disc is loaded (“NO DISC” is displayed).
“A.S.ON” (Auto Standby On) and “A.STANDBY” will be lit on the display window on the main unit.
When a stopped state is entered (after playback is finished, for example), “A.STANDBY” starts blinking.
This means that the power will be turned off automatically if there is no operation for 3 minutes. And, 20 seconds before the power is turned off, “POWER OFF” will appear blinking.
Releasing Auto Standby
Press A.STANDBY.
“A.S.OFF” (Auto Standby Off) will appear and “A.STANDBY” will be turned off on the display window on the main unit.
NOTE
When the source is FM/AM or AUX, Auto Standby does not work.
35