Assembly

To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove all
packing materials; do not dispose of the packing materials until assembly is completed. Assembly requires the
included hex keys and your own adjustable wrench		, Phillips screwdriver	, and
rubber mallet	.

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe- ses below each drawing is the key number of the part. The number following the parentheses is the quantity needed for assembly. Note: Some small parts shown in the assembly steps may be pre-assembled. If a part is not found in the parts bag, check to see if it is pre-assembled.

M8 Split	M10 Split	M8	Handlebar	M10
Washer (28)–4	Washer (45)–2	Washer (71)–4	Washer (55)–2	Washer (35)–2
Wave	Large Wave	M8 Nylon	M10 Nylon	M4 x 22mm
Wave	Large Wave	M8 Nylon	M10 Nylon	Screw (63)–2
Washer (69)–2	Washer (76)–2	Locknut (38)–4	Locknut (33)–6
M8 x 25mm Patch		M8 x 52mm Button		M10 x 27mm
Screw (56)–2		Screw (27)–4		Patch Screw (40)–2
M10 x 74mm Button Bolt (7)–2			M10 x 75mm Carriage Bolt (34)–4
M8 x 45mm Button Bolt (50)–4			M6 Bolt Set (25)–2
		5