ASSEMBLY
Place all parts of the AIR WALKER in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read through all assembly steps before you begin.
Assembly requires the included allen wrench
and adjustable wrench 
.
1.Refer to figure 1a. Stand at the front of the AIR WALKER, hold the Frame (1) in the indicated locations, and raise the AIR WALKER to the position shown. Refer to figure 1b. Put your foot on the round tube. Using your foot, pull the round tube toward yourself until the Uprights (5, 6) are fully extended. Before you proceed with assembly, make sure that the Uprights are fully extended and are resting against the stops (see figure 1a).
2.Slide a Lock Washer (16) onto the Lock Knob (32). Insert the Lock Knob into the hole near the top of the Left Leg (2). Tighten the Lock Knob into the Link Plate (7).
3.The Electronic Monitor (9) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended. Press the tab on the battery cover and remove the battery cover from the Monitor. Insert two batteries into the Monitor. Make sure that the negative (Ð) ends of the batteries are touching the springs in the Console. Close the battery cover.
and your own phillips screwdriver 
Fig. 1a |
| Fig. 1b |
| |
| Hold |
|
| |
| Here |
|
| |
|
|
| 1 | |
5 | Stop | 5 | Foot | |
6 |
|
| ||
|
|
| ||
| 1 |
|
| |
Back | Front | Round | 6 | |
Tube | ||||
|
|
| ||
Fig. 2 |
|
|
| |
| 16 | 32 |
| |
7 | 2 |
|
| |
Fig. 3 |
|
|
| |
|
| 9 |
| |
|
|
| Batteries | |
|
|
| Battery | |
|
| Tab | Cover |
4