ProForm 831.288272 manual Assembly, Wrenches , and a phillips screwdriver

ASSEMBLY

Place all parts of the exercise bike in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools, two adjustable

wrenches , and a phillips screwdriver .

To identify the small parts used in assembly, refer to the drawings below. The number in parenthesis below each drawing refers to the key number of the part, from the part list on page 11. The second number refers to the quantity used in assembly. Note: If a part is not in the parts bag, check to see if it has been pre-assembled.

M4 x 16mm Screw (22)Ð4

M8 Nylon Locknut (20)Ð4 M10 Split Washer (26)Ð5

M10 Nylon Locknut (58)Ð6	M8 Split Washer (41)Ð4		M10 x 25mm Button Head Screw (25)Ð5
M10 x 45mm Button Head Screw (46)Ð2		M10 x 58mm Carriage Bolt (59)Ð4
1. Press two 2Ó x 3Ó Endcaps (48) into the Rear		1			58
Stabilizer (61).
						48
Position the Rear Stabilizer (61) under the
angled bracket on the rear of the Frame (1).
Make sure that the Rear Stabilizer is turned so				1
the recessed holes are on the bottom. Attach the
						61
Rear Stabilizer with two M10 x 58mm Carriage
Bolts (59) and two M10 Nylon Locknuts (58).
		48				Recessed
					59	Holes
2. Press two 2Ó x 3Ó Endcaps (48) into the Front		2
Stabilizer (60). Attach a Wheel (47) to one of the			58
brackets on the Front Stabilizer with an M10 x
45mm Button Head Screw (46) and an M10			1
Nylon Locknut (58). Attach a Wheel to the other
bracket on the Front Stabilizer in the same way.
		47	58	60
Position the Front Stabilizer (60) under the
angled bracket on the front of the Frame (1).		46			48
Make sure that the Front Stabilizer is turned so
the recessed holes are on the bottom. Attach the
Front Stabilizer with two M10 x 58mm Carriage					Recessed
Bolts (59) and two M10 Nylon Locknuts (58).				59
					Holes
				48
		4