ASSEMBLY
Assembly requires two persons. Place all parts of the PROFORM¨ REBEL in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver 
, two adjustable wrenches 
and a
rubber mallet 
(none of these is included).
1.Hold the Stabilizer (68) against the saddle on the rear of the Base (1). Attach the Stabilizer with two M10 x 75mm Bolts (66) and two M10 Nylon Locknuts (54).
2.Slide the
Insert two M10 x 68mm Bolts (67) with two M10 Washers (71) up through the Base (1) and the Rail Stabilizer (37). Note: It may be easier to insert the
Bolts if the unit is tipped on its side.
Insert two M10 x 68mm Bolts (67) with two M10 Washers (71) up through the Rail Stabilizer (37).
3.While one person holds the Upright (2), connect the Extension Wire (49) to the Reed Switch Wire (48) extending from the Base (1). Insert any excess wire into the Upright or the Base.
Slide the Upright (2) onto the four M10 x 68mm Bolts (67). Make sure that the wires do not get pinched as you slide the Upright into place.
Hand tighten an M10 Nylon Locknut (54) onto each M10 x 68mm Bolt (67). Tip the unit on its side and use two spanners to tighten the Nylon Locknuts fully.
1 | 54 |
| 1 |
54 |
|
| 68 |
| 66 |
2 |
|
37 | |
| |
| 48 |
| 71 |
67 | 1 |
3 |
|
54 | 54 |
| |
2 |
|
| 49 |
| 48 |
| 1 |
67 |
|
5