Maintenance and TROUBLE-SHOOTING, Console, Storage

MAINTENANCE AND TROUBLE-SHOOTING

Inspect and tighten all parts each time you use the cross-country skier. Keep liquids away from the con- sole. Once every three months, apply a few drops of light multi-purpose oil to the hubs of the pulleys at the ends of the ski pedal strap.

CONSOLE

If the console does not function properly, or if the LCD display becomes faint, the batteries should be replaced. See INSTALLING BATTERIES IN THE CONSOLE on page 6 for instructions. Make sure that the console wire is plugged fully into the console and the reed switch wire. See assembly steps 7 and 8 on page 5.

SKI PEDALS

If the ski pedals are difficult to move, the ski pedal strap may be too tight. The tension should be decreased. See ADJUSTING THE TENSION OF THE SKI PEDAL STRAP on page 6 for instructions.

If the movement of the ski pedals becomes rough or noisy, clean the ski rails and the ski pedal rollers with a soft, dry cloth. Next, apply a non-oil-, non-petroleum base silicone lubricant to the rails where the rollers make contact. (We recommend Uni•Sport™ spray, which can be ordered by calling our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time. Lubricant is also available at most automotive and hardware stores.) Apply lubricant at least once every three months.

If the movement of the ski pedals is still rough, the rollers may need to be replaced. See ORDERING REPLACEMENT PARTS on the back cover of this manual.

SKI POLES

If the ski poles squeak when they are moved, a small amount of grease may be applied to the four resis- tance pads on each ski pole housing. See assembly steps 1 to 3 on page 4 to see how to remove the ski pole housings.

If the ski poles have little resistance, even when the resistance dial is turned clockwise, the resistance pads should be replaced. See ORDERING REPLACEMENT PARTS on the back cover.

STORAGE

Loosen the	Resistance Dial
resistance dial	Resistance Dial
and lower the
ski poles.
Press down on
the front of the
upright bracket
and lower the	Upright Bracket
upright.
Remove the
batteries from

the console. Cover the cross-country skier during extended periods of storage.