AE2720 Pedometer
INSTRUCTIONS
Congratulations on taking the first step to wellness with your purchase of an ACCUSPLIT pedometer.
It’s easy to set up your new pedometer.
Just follow the steps below, and start walking!
DISPLAY MODES
• STEP: STEP mode shows your step count since last reset, up to 1,000,000 steps.
• ◯: ACTIVITY TIMER MODE shows total activity time in minutes and seconds since last reset. The timer runs automatically whenever steps are being recorded.
9789 ▶ �
STEP
ACCUSPLIT EAGLE
Red:White:
MODE RESET
HOW TO OPEN YOUR PEDOMETER |
|
|
|
|
|
See diagrams at right. |
|
|
|
|
|
The cover must be closed for the |
| 68440 | PEDOMETER | ||
| 0 |
| STEP |
| |
pedometer to work. |
|
| 1520 | ACTIVITY | |
| STEP10000.ORG |
| |||
| ACCUSPLITALL | IANCE |
|
| |
| ACCU |
|
|
| |
|
|
| RESET� |
| |
WEARING YOUR PEDOMETER
Gently slide the pedometer onto
your belt or the top edge of your | yes |
pants or skirt. It should fit snugly |
|
and level, above one knee. The | no |
strong polycarbonate clip makes | |
it easy. |
|
Note: The pedometer should be as vertical as possible. Walkers with larger stomachs may find it helpful to wear the pedometer farther back on the body, toward one hip.
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will automatically begin to record your steps, and activity time. Repeatedly press the red MODE button to cycle through the pedometer modes:
STEP → ACTIVITY TIMER → STEP
2-STEP DELAY FILTER
ACCUSPLIT has added a “2 step delay” filter to this pedometer, to weed out false steps caused by tapping the foot, sitting down, etc. The filter is set to “2 steps,” meaning that the unit will wait to start counting steps until more than two steps have been recorded. When you are beginning a walk, the display will not show any steps for a few seconds. After the unit has sensed three steps, the display will register all of those steps at once, and keep counting from that point.
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: press and hold the white RESET button for at least 2 seconds.
The cover must be closed for the pedometer to work. | REPLACING THE BATTERY | ||
To avoid losing or dropping your pedometer, use the | When the display starts to dim or goes blank, it is time to | ||
included leash and clip to fasten the pedometer securely | replace the battery. Your pedometer uses one Type L1142 | ||
to your clothing. |
| (LR43) 1.5 volt silver oxide battery. | |
|
|
| To replace: |
ATTACHING THE LEASH |
|
| 1. Insert a coin into the slot on the front of the |
First, loop the |
| case, and twist | |
Attach the pedometer to the | pedometer leash slot |
| the battery door. |
|
|
| |
leash by looping the leash | Next, loop the metal |
| 2. Remove battery door and take out the old |
through the pedometer leash | clip, then clasp clothing |
| |
slot. Next, loop the leash |
|
| battery. Replace it with a new battery. The |
through the metal clip, then |
|
| battery’s positive (+) terminal should be |
clasp the waistband of your |
|
| FACE UP while you put it into the |
clothing with the pedometer |
|
| pedometer. |
belt clip. |
|
| 3. Put the battery door back on and twist the |
Note: You can also use a safety |
|
| coin clockwise to tighten. |
|
|
| |
pin to fasten the leash to |
| badge holder, | Eat Right! Walk More! |
through your belt or belt loop, |
| ||
your clothing, loop the leash |
| Or, loop a |
|
or use a badge holder. | Or, loop a belt or belt loop | then put into pocket | Live Well! |
not included) | |||
| (Badge holder |
| |
|
|
| The ACCUSPLIT Lifestyle |
|
|
| |
ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA