The wood case may be dusted with a slightly damp cloth and it is generally not advisable to apply a dusting agent. Wax buildup and dirt will darken the case with years of use and could destroy the original finish.
Moving the Clock
At some point it may become necessary to relocate the clock. This may be done safely if certain measures are taken.
1.Allow the clock to run until the weight is well down in the case but not touching the bottom.
2.Remove the pendulum by: Stop the pendulum from
swinging; remove the screw at the top; get a good grip (the pendulum is pretty heavy); with a finger on the leader, gently lift the pendulum up and away (it is held on with a pin); replace the screw in the leader to prevent it from being lost.
3.Remove the weight by lifting up on the weight cover cap and then unhooking the weight from the cable.
4.Remove the movement from the case by loosening the two seat board screws located behind the dial and under the movement. The movement will slide off of the seat board.
Once
Setup After Moving
Stability of the case is the most important part of setting up the clock. The case must be back against the wall in such a manner that the top touches on both sides. A good test is to push against the top to see if there is any give. If there is, it may be necessary
16