Foldover Clasp Bracelet, Bracelet Link Removal

INDIGLO® NIGHT-LIGHT

Press crown to activate light. Patented (U.S. pat. 4,527,096 and 4,775,964) electroluminescent technology used in the INDIGLO® night- light illuminates entire watch face at night and in low light conditions.

		WATER RESISTANCE
If your watch is water-resistant, meter marking or (				) is indicated.

	Water-Resistance Depth		p.s.i.a.* Water Pressure Below Surface
	Water-Resistance Depth		p.s.i.a.* Water Pressure Below Surface
	30m/98ft			60
	50m/164ft			86
	100m/328ft			160
	200m/656ft			284
	200m/656ft			284

*pounds per square inch absolute

WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS OR PULL OUT THE CROWN UNDER WATER UNLESS YOUR WATCH IS INDICATED AS 200 METER WATER-RESISTANT.

1.Watch is water-resistant only as long as crystal, crown and case remain intact.

2.Watch is not a diver watch and should not be used for diving.

3.Rinse watch with fresh water after exposure to salt water.

4.Shock-resistance will be indicated on the watch face or caseback. Watches are designed to pass FTC test for shock-resistance. However, care should be taken to avoid damaging crystal.

BRACELET ADJUSTMENT

Fig. 1

Fig. 2

Fig. 3

FOLDOVER CLASP BRACELET

Find spring bar that connects bracelet to clasp. Using a pointed tool (Fig. 1), push spring bar in and gently twist bracelet to disengage. Determine wrist size, then insert spring bar in correct bottom hole (Fig. 2). Push down on spring bar, align with top hole and release to lock in place (Fig. 3).

Bracelet Link Removal

Removing Links: Place bracelet upright and insert pointed tool in opening of link. Push pin forcefully in direction of arrow until link is detached (pins are designed to be difficult to remove). Repeat until desired number of links are removed.

Reassembly: Rejoin bracelet parts. Push pin back into link in opposite direction of arrow. Press pin down securely into bracelet until it is flush.

SOLID LINK BRACELET

Removing Links: Using a very small screwdriver, remove screws by turning COUNTERCLOCKWISE. Repeat until desired number of links are removed. Do not remove links adjacent to clasp.

Reassembly: Rejoin bracelet parts and insert screw in end of opening where it was removed. Turn screw clockwise until tight and flush with bracelet.