NOTE: Press and hold START/SPLIT to quickly scroll through all data.
ATTENTION: You will see the message NO DATA STORED if the Chrono has never been run.
TIMER MODE
Your WS4™ watch includes a standard countdown timer that you can use for both outdoor and indoor activities. It can count down from a fixed time of up to 100 hours and can repeat a countdown up to 99 times.
Setting the Timer
1.Press MODE until TIMER is shown.
2.Press and hold SET to start.
3.Press START/SPLIT (+) or STOP/RESET
4.Press MODE (NEXT) to advance to the next setting option.
5.Press SET (DONE) to finish.
Operating the Timer
1. | Press START/SPLIT to start the timer or restart it after a pause. |
| |
E | |||
2. | Press STOP/RESET to stop the countdown. |
3.Hold STOP/RESET to reset the timer to the start value.
4.Hold STOP/RESET again to clear the timer to 0.
When the countdown reaches zero the watch will beep. You can press any button to silence the beep. If you set the timer to repeat at the end of the count- down, the repeat will continue until you press STOP/RESET. The display will show R and a number to indicate the timer is repeating and how many times it has repeated.
TIP: The timer might be useful when you want to be alerted at the halfway point of an activity. For example, you go out knowing you only have about two hours to spend on a hike. You set the timer for 60 minutes and when it beeps you know it’s time to turn around and start heading back to the trail head. Timer information is not connected to Review Mode.
32 | 33 |