Sharper Image SN005 manual Setting Alarm

Page 21

Manual Setting

Press and hold the SET/LIGHT button for 2 seconds to set the target hour, minute and seconds. When hour, min-

ute and seconds are flashing, press UP or DOWN button to adjust. When finished, press UP button and the watch starts the countdown. Press UP button again to stop the

countdown and DOWN button to reset the countdown. When the countdown has reached to the target time, the alarm sounds. To stop the alarm, press any button.

Note: The default is at 5 minutes.

Setting Alarm 1

When you are in Mode B, press the MODE button to enter Mode C: Alarm 1. (See Figure 7.) When entering the alarm

mode, the on/off flashes. Press UP or DOWN button to

21

Image 21
Contents Global Atomic Watch Page Page Table of Contents What is Atomic Radio Control? What is Atomic Radio Control? What is Atomic Radio Control? Buttons Replacing the Battery Auto Synchronization Auto Synchronization How to position the watch for the best signal reception Auto Synchronization Auto Synchronization Auto Synchronization Reading Other Data or Setting the Watch Normal Display Mode D Alarm Mode E Mode a Stopwatch Display Manual Setting Setting the Time and Calendar Countdown Function Stopwatch FunctionSetting Alarm Selecting the Country Turn the alarm on or off. Next, press and hold the SETSetting the Offset Offset time. Press SET/LIGHT button when finished Backlight What Is Covered WarrantyHow to Obtain Service