Seiko 6M25, 6M26 manual Necessary Procedure After Battery Change

Page 20

English

NECESSARY PROCEDURE AFTER BATTERY CHANGE

●When the battery is replaced, the information stored in the IC does not correspond with the time and date actually displayed. Before using the watch, therefore, be sure to reset the hands and date, following the procedure below.

CROWN

➡

Turn to set MODE INDICATOR to “CHRONO.”.

*If the stopwatch is counting, first press Button B to stop measurement and then press Button A to reset the hands.

B

➠

7

A

CROWN

➡

	CROWN	Pull out.
	▼	Press and hold at the same time
	A AND B	Press and hold at the same time
	A AND B	for 2 seconds.

*A beep sounds when the buttons are released, and the hands start to show demonstration movement.

▼
A OR	B Press to stop the hands.

20

▼

Image 20

Contents Cal M25, 6M26 English Contents Features Seiko Analogue QuartzModes and Displays There are two buttons and a crownMode Change Adjusting the Hand and Date Positions HOW to Reset the Hand and Date PositionsCrown Time Setting CrownThemonthisindicatedbythehourmarkerthatallthreehandspointto Calendar SettingCalendar Alarm Alarm SettingAlarm ENGAGEMENT/DISENGAGEMENT Alarm engagement Alarm disengagementTimer Timer SettingTimer Operation Start Stop Restart ResetStopwatch HOW to Read the HandsOther modes Stopwatch mode For the first 1 minute After the first 1 minute Measured Stopwatch Operation Tachymeter To measure the hourly average speed of a vehicleTo measure the hourly rate of operation Necessary Procedure After Battery Change Second hand Minute hand Date Hour hand Remarks on timer operation Remarks on stopwatch operation Demonstration movement of handsBattery Life Indicator Battery ChangeEnglish 10/15/20 bar To Preserve the Quality of Your WatchNon-water Resistant Water resistant 5/10/15/20 bar Since swimming movement tends toShocks & Vibration Specifications Chrono