STEP 2 | (SEE DIAGRAM 2) |
| |
A.) | Connect the Main Seat Support (#1) to the Rear Stabilizer (#14). Secure them with | ||
| one Bracket (#17), two M10 x 3 ¾” Carriage Bolts (#47), ∅ | 7/8” Washers (#48) and | |
| M10 Aircraft Nuts (#50). |
| |
B.) | Connect the Main Seat Support (#1) to the Front Stabilizer (#56). Secure them with | ||
| one Bracket (#17), two M10 x 3 ¾” Carriage Bolts (#47), ∅ | 7/8” Washers (#48) and | |
| M10 Aircraft Nuts (#50). |
| |
C.) | Slide the Sliding Block (#10) onto the Chromed Incline Adjustment Bar (#11). Align | ||
| the holes then thread a Pull Pin (#37) into the hole to hold the Sliding Block at the | ||
| position. |
|
|
D.) | Attach two Bushings (#54) to the Chromed Incline Adjustment Bar (#11). Then | ||
| attach the Bushings and Bar to the bracket on the Main Seat Support (#1). Secure | ||
| it with one M10 x 3” Allen Bolt (#41), two ∅ 7/8” Washers (#48), and one M10 | ||
Aircraft Nut (#50).
DIAGRAM 2
5