Assembly Instruction

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.

NOTE: It is strongly recommended two or more people assembling this machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Connect the Right and Left Upright Beams (#1 & #2) with a Cross Brace (#3) in the mid-span. Secure each end with two M10 x 4 ¾” Carriage Bolts (#54), one 5 ½” x 2” Bracket (#46), two Ø ¾” Washers (#64), and two M10 Aircraft Nuts (#67).

B.) Attach a Weight Post (#14) to the rear diagonal support on the Left Upright Beam. Secure it with one M10 x ¾” Allen Bolt (#59) and ∅ ¾” Washer (#64). Slide an Olympic Sleeve (#44) onto the Weight post. Attach a Spring Clip (#48) to the Sleeve. Repeat the same procedure to install the other side.

C.) Place the Backrest Adjustment Bar (#29) onto the selected slot on the Upright Beams.

D.) Attach the Left & Right Squat Bar Catches (#11 & #12) onto the two Upright Beams. Insert the Right & Left Bar Catches (#7 & #8), Right & Left Safety Catches (#9 & #10) into the selected holes on the two Upright Beams.