ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended two or more people assembling this machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) | Do NOT tighten the nuts and bolts until instructed to do so. |
B.) | Slide two Ø2 ½” Round Rubber Bumpers (#43) onto the Guide Rods (#7). Insert |
| the two Guide Rods into the holes on the Rear Stabilizer (#8). Secure each Guide |
| Rod with one M10 x 1” Allen Bolt (#72) and ∅ ¾” Washer (#79) from the bottom. |
C.) | Attach the rear of Main Base Frame (#1) to the Rear Stabilizer. Secure them with |
| two M12 x 4” All Bolts (#69), one 4” x 1 ½” Bracket (#20) and four Ø 1” Washers |
| (#81). Do not tighten the nuts and bolts yet. |
D.) Attach the Front Base Frame (#19) and to the Main Base Frame (#1). Secure | |
| them with two M10 x 2 3/8” Carriage Bolts (#78), Ø ¾” Washers (#79), and M10 |
| Aircraft Nuts (#82). |
E.) | Place the Vertical Frame (#2) onto the Main Base Frame. Secure them with two |
| M10 x 2 3/8” Carriage Bolts (#78), one Pulley Bracket (#18), two Ø ¾” Washers |
| (#79), and two M10 Aircraft Nuts (#82). |
7