Assembly Instruction

Tools Required Assembling the Machine: Two Adjustable Wrenches, two Allen

Wrenches, and one Philips Screwdriver. NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.

STEP 1 (See Diagram 1)

A.)	Connect two Lower Guide Rods (23) and two Upper Guide Rods (#24) with two M10
	Stud Bolts (#80). Firmly thread the Rods together.
B.)	Insert the Lower Guide Rods (#23) into the holes on the Rear Base Frame (#2).
	Secure it with two M10 x 1” Allen Bolts (#73) and Ø ¾” Washers (#83) from the
	bottom.
C.)	Attach the Main Base Frame (#8) to the Rear Base Frame (#2). Secure it with two M10
	x 2 ½” Carriage Bolts (#79), one 4” Bracket (#30), two Ø ¾” Washers (#83), and two
	M10 Aircraft Nuts (#85).
D.)	NOTE: Do not tighten all the Nuts and Bolts until instructed to do so.
E.)	Attach the Lower Vertical Frame (#3) onto the Main Base Frame (#8). Secure it with
	two M10 x 2 ½” Carriage Bolts (#79), one 4 ¾” Bracket (#29), two Ø ¾” Washers
	(#83), and two M10 Aircraft Nuts (#85).
F.)	Attach the Leg Developer Holder (#1) to the Main Base Frame (#8) and Front Base
	Plate (#15). Secure them together with two M10 x 2 ½” Carriage Bolts (#79), one 4 ¾”
	Bracket (#29), two Ø ¾” Washers (#83), and two M10 Aircraft Nuts (#85).
G.)	Attach the Seat Support (#16) to the Leg Developer Holder (#1). Secure it with one
	M10 x 2 3/8” Allen Bolt (#71), two Ø ¾” Washers (#83), and one M10 Aircraft Nut
	(#85).
H.)	Attach the Seat Support (#16) to the Lower Vertical Frame (#3). Secure it with two M10
	x 2 ½” Carriage Bolts (#79), one 4 ¾” Bracket (#29), two Ø ¾” Washers (#83), and two
	M10 Aircraft Nuts (#85).
I.)	Attach the Upper Vertical Frame (#14) to the Lower Vertical Frame (#3). Secure them
	with four M10 x 2 ½” Carriage Bolts (#79), two V-shaped Brackets (#27), four Ø ¾”
	Washers (#83), and four M10 Aircraft Nuts (#85).
J.)	Attach the Stopper Frame (#25) to the Upper Vertical Frame (#14). Secure it with one
	M10 x 2 3/8” Allen Bolt (#71) and Ø ¾” Washer (#83).