See Diagram 5 & Cable Loop Diagram

STEP 5 (See Diagram 5 & Cable Loop Diagram)

A.)	Attach the 134” Upper Cable (#31) to the open bracket under the front of the
	Upper Frame (#4). Note: The Ball Stopper on the cable should be underneath
	the Frame.
B.)	Attach a Pulley (#60) to the open bracket. Secure it with one M10 x 1 ¾” Allen
	Bolt (#69), two Ø ¾” Washers (#80), and one M10 Aircraft Nut (#82).
C.)	Draw the Cable over the Pulley through the opening on Front Press base (#11)
	towards the back of the machine to the open bracket on the Front Vertical Frame
	(#3). Repeat step B above to install a Pulley.
D.)	Draw the Cable around the Pulley then pull back towards the opening on the
	Front Press Base (#11).
E.)	Attach a Pulley to the opening on the Front Press Base. Secure the Pulley with
	one M10 x 6 7/8” Allen Bolt (#65), two Ø ¾” Washers (#80), and one M10
	Aircraft Nut (#82).
F.)	Draw the Cable around the Pulley and through to the open bracket on the back
	of Front Vertical Frame (#3). Repeat step B above to install another Pulley.
G.)	Draw the Cable around the Pulley then pull the Cable downwards. Attach the
	Cable to a Double Floating Pulley Bracket (#16). Install another Pulley. Let the
	bracket hanging for now.
H.)	Pull the Cable upward to the open bracket on the top of Upper Frame. Attach
	two L-shaped Cable Retainers (#84) on top of two Pulleys. Install two pulleys to
	the bracket.
I.)	Pull the Cable downward between the two Guide Rods to the Selector Rod
	(#13). Thread the bolt at the end of the Cable into the opening on top of the
	Selector Rod (#13) to secure the Cable.