Impex SB 210 manual Assembly Instruction, Diagram

ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches

NOTE: It is strongly recommended this machine be assembled by two or more people to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Slide the Sliding Block (#9) onto the Main Frame (#2) and secure it with a Quick Release Knob (#13).

B.) Attach the Rear Stabilizer (#8) to the Main Frame (#2). Secure it with two M10 x 5/8” Allen Bolts (#24) and ∅ ¾” Washers (#31).

C.) Attach the Front Stabilizer (#7) to the Front Vertical Frame (#1). Secure it with two M10 x 5/8” Allen Bolts (#24) and ∅ ¾” Washers (#31).

D.) Attach the Main Frame (#2) to the Front Vertical Frame (#1). Secure it with a M10 x 2 7/8” Allen Bolt (#26), two ∅ ¾” Washers (#31), and one M10 Aircraft Nut (#34) to the lower hole. NOTE: DO NOT over tighten the bolt. The joint needs to swivel in able to fold the bench for storage. Insert a L-shaped Lock Pin (#15) to the upper hole.

E.) Attach two L-shaped Brackets (#10) to each side of Main Frame. Secure the brackets with two M10 x 2 ½” Allen Bolts (#25), four Ø ¾” Washers (#31), and two M10 Aircraft Nuts (#34). Do not tighten the nuts and bolts yet. After installing the seat pad, then come back to this step to tighten the nuts and bolts.

DIAGRAM 1

4