Count Up, Count Down | Impex PL 200 guide

Operating the Computer

Count Up

The computer can be turned on by pressing any of the three keys or by simply pedaling the bike. The values for Time, Dist, and Cal will start from Zero and accumulates upward. To reset all values back to Zero, Press and Hold Down the Enter key for two seconds.

Count Down

By pre-setting a value in the computer, the function will count down from the preset value back to Zero. When the value reaches Zero, the alarm will go off.

For example, you want to work out for 5 minutes. Press the Enter key so the Time starts flashing. Press Up key until 5:00 shows up. Press Enter. You can repeat the same procedure to enter Distance and Calorie.

Note:

Please note all values on this computer are approximate and they are for comparison purpose only. Do Not use these values for any medical or rehabilitation purpose.

Maintenance and Storage

1.Inspect and tighten all parts each time you use the machine. Replace any worn parts immediately.

2.The bike can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

3.Store the machine IN-DOOR. Excess moisture and water would cause rust on the frame.

4.The machine shall be placed at least 24 inches away from the wall or/and any other object such as furniture to provide safe access to and passage around the machine.

5.To avoid possible injury, the help of two or more people are needed when moving the machine around.