Impex PHC 750 manual Assembly Instruction

Page 5

ASSEMBLY INSTRUCTION

Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen Wrenches

NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Connect the two Upright Beams (#1) by a Cross Brace (#2) in the mid-span. Align the holes and secure them with one Bracket (#20), two M10 x 3 1/8” Carriage Bolts (#38), two ¾” Washers (#45), and two M10 Aircraft Nuts (#44) on each end of the Cross Brace.

B.) Place Backrest Adjustment Bar (#4) between the two Upright Beams on the selected bar holder to obtain desired incline of Backrest.

C.) Insert two Crutches (#7) into the top openings on the Upright Beams. Secure them with two Lock Knobs (#23) through selected holes to obtain desired height of the Supports.

D.) Slide a Rubber Bumper (#22) onto a Weight Post (#8). Insert the Post into the hole on the back of the Upright Beam (#1). Secure it with one M10 x 1” Allen Bolt (#37) and ¾” Washer (#45). Repeat the same step to install the other side.

DIAGRAM 1

4

Image 5
Contents Powerhouse Club Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Important Safety Notice Page Assembly Instruction Diagram Diagram See Diagram Page Parts List Impex INC