JVC UX-M6VUB manual Common Operations, Turning On or Off the Unit, Setting the Clock

Common Operations Continued

English

Turning On or Off the Unit

To turn on the unit

Press	STANDBY/ON on the		STANDBY/ON
unit or remote control.		STANDBY	or
The unit turns on with the last		/ON
source selection remaining valid.

To turn off the unit (on stanby)

Press STANDBY/ON on the unit or remote control. “BYE BYE” scrolls through briefly and the clock time appears if the clock is already set.

Setting the Clock

Before operating the unit any further, first set the built-in clock.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1 While the unit is on, press and	PROGRAM
hold PROGRAM until “24” or
“12” HOUR starts blinking.

• When the unit is in standby mode, press PROGRAM once.

On clock resetting

If a power failure occurred or the AC power cord is disconnected, the clock is reset to “0:00” (flashing). In such a case you need to set the clock again.

Adjusting the Volume

• You can adjust the volume only while the unit is turned on.

Press VOLUME + or VOLUME – to
increase or decrease the volume level.	VOLUME

The volume can be adjusted in 33 steps between “VOL MIN” (minimum) and “VOL MAX” (maximum).

To increase or decrease the volume level rapidly, press and

hold VOLUME + or VOLUME –.

To turn off the sound temporarily

MUTING

Press MUTING on the remote control. The source name and muting indication scroll through the display, and playback continues without sound.

To restore the sound, press MUTING again or increase or decrease the volume level.

2 Press 4 or ¢ to select 12-

or 24-hour mode, then press

PROGRAM.

The hour indication starts blinking.

SEARCH/TUNING

DO NOT turn off the unit (on standby) with the volume set to an extremely high level; otherwise, a sudden blast

of sound can damage your hearing and/or the speakers when you turn on the unit or start playing any source next time.

3 Press 4 or ¢ to set the	PROGRAM
hour then press PROGRAM.

The minute indication starts blinking.

4 Press 4 or ¢ to set the minute, then press PROGRAM to store the setting.

The clock starts working.

To change the hour or minute indication rapidly in steps 3

and 4, press and hold 4 or ¢.

To check the clock time while the unit is on

Press DISPLAY.	DISPLAY
The clock time is displayed until you press any
key.

•In 12-hour mode, “AM 12:00” indicates midnight and “PM 12:00” indicates noon.

To correct the clock time

Carry out steps 1 to 4 above.

– 8 –