STEP 7 (See Diagram 7) |
| |
A.) | Attach the Front Vertical Frame (#54) to the Rear Stabilizer (#53). Secure it with two | |
| M10 x 5/8” Allen Bolts (#88) and ∅ ¾” Washers (#42). |
|
B.) | Attach one end of the Cross Brace (#51) to the left Rear Upright Beam (#48). Attach the | |
| Left Support (#50) to the other side of the left Rear Upright Beam. Align the holes. | |
| Secure them with two M10 x 2 ¾” Carriage Bolts (#81), ∅ ¾” Washers (#42), and M10 | |
| Aircraft Nuts (#44). Do not tighten all the nuts and bolts yet. |
|
C.) | Secure the other end of the Left Support (#50) to the Left Upright Beam (#47) with two | |
| M10 x 5/8” Allen Bolts (#88) and Ø ¾” Washers (#42). |
|
D.) | Repeat Step B and C above to install the other side. |
|
E.) | Securely tighten all nuts and bolts previously installed. |
|
F.) | Attach the Rear Vertical Frame (#52) to the rear bracket on the Front Vertical Frame | |
| (#54). Secure it to the Front Vertical Frame with two M10 x 5/8” Allen Bolts (#88) and ∅ | |
| ¾” Washers (#42). |
|
G.) | Attach the Rear Vertical Frame (#52) to the Cross Brace (#51). Secure it with two M10 x | |
| 2 3/8” Carriage Bolts (#80), one 4 3/8” x 2 3/8” Bracket (#65), two ∅ | ¾” Washers (#42) |
| and two M10 Aircraft Nuts (#44). |
|
H.) | Insert two Weight Posts (#63) to the holes on the Left & Right Supports (#50 & 49). | |
| Secure each Weight Post with one M10 x 5/8” Allen Bolt (#88) and ∅ | ¾” Washer (#42). |
| Slide an Olympic Sleeve (#20) onto each Post. Attach a Spring Clip (#22) to the Olympic | |
| Sleeve. |
|
I.) | Insert the Left & Right Bar Holders (#93 & 92) into the selected holes on the Upright | |
| Beams. Insert the Left & Right Safety Catches (#58 & 59) into the selected holes on the | |
| Upright Beams. |
|
11