STEP 5 (See Diagram 5)
A.) Insert the Leg Developer Holder into the Main Seat Support (#2).
B.) Thread a Lock Knob (#22) into the Nut on the Main Seat Support (#2) to hold the Leg Developer Holder (#5) at desired height.
C.) Attach the Leg Developer (#3) to the open bracket on the Leg Developer Holder. Secure it with an Axle (#31), two M10 x 5/8” Allen Bolts (#38), and two Ø ¾” Washers (#33).
D.) Insert two Foam Tubes (#12) halfway through the holes on the Leg Developer. Push four Foam Rolls (#20) onto the Tubes from both sides. Plug four Foam Roll End Caps (#24) into the ends of the Tubes.
E.) Attach an Olympic Sleeve (#30) onto the weight post on the Leg Developer. Attach a Spring Clip (#29) to the Olympic Sleeve.
DIAGRAM 5
26